|
|
|
|
|
|
|
|
|
Neck
|
The part of a container where the shoulder cross section area decreases to form the finish. an illustrated example of the neck can be found at the cap and neck finish page.
|
Neck, английский
Hals, немецкий
Neck, английский
Hals, nacke, шведский
|
Illustrated, английский
|
Tolerance, английский
- The permissible maximum deviation from specified dimensions, quantities, or specifications. the amount of variation allowed from the nominal dimension.
- A specified allowance for error from a standard or given dimension, weight or property.
- The amount of acceptable difference between a known correct standard (usually the customer's specifications) and a set of measured samples. see delta error.
- Допуск. допустимое отклонение, терпимость. выносливость.
- Допуск; зазор
- A permissible allowance for variation from standard in a prescribed parameter.
- The permissible deviation in a specified size or dimension. tollhouse 1. a house near a tollgate of a highway or bridge, serving as the residence of the keeper. 2. a tollbooth. toltec architecture an austere geometric mesoamerican architecture, ca. 1000 a.d., which
- The ability of the body to tolerate a substance or an action he has been taking the drug for so long that he has developed a tolerance to it. ‘26 patients were selected from the outpatient department on grounds of disabling breathlessness, severely limiting exercise tolerance and the performance of activities of normal daily living’ [lancet]
- N терпимость, толерантность tomography n томография computed ~, computer-aided ~ компьютерная томография
- Толерантность. снижение терапевтического эффекта препарата при его постоянном применении. выделяют острую (тахифилаксия) и хроническую, фармакодинамическую и фармакокинетическую толерантность. встречающиеся термины: переносимость, привыкание.
- Tolerance
- A specified allowance (either plus or minus) of the given dimension of a finished product to take care of inaccuracies in workmanship of parts to be fitted together. the amount allowed as tolerance is generally small as compared with the standard dimension of the part; for example, the tolerance allowed in the set diameters of a diamond bit is plus or minus five-thousandth (0.005) of an inch.
- Допуск; допускаемое отклонение о ~s for inaccuracies of erection допуски на неточности монтажа; ~s
- One system`s non-reactivity to a range of inputs which would normally elicit responses in other systems of the same kind (->equivocation) •
- Допуск
- The permissible variations in the dimensions or other characteristic of a part or substance.
- Lack of an anti-self immune response
- Term describing deviation from the prescribed dimensional specifications for bore, o.d. and ring widths of standard bearings; the slighter the deviation, the smaller the tolerance and the closer the bearing comes to precision. the annular bearing engineering committee has standardized the tolerances for ball bearings, and the roller bearing engineering committee has developed similar tolerances for roller bearings; higher numbers mean greater precision.
- The specified permissible deviation from a specified nominal dimension, or the permissible variation in size of a part.
Closure height, английский
The overall height of the closure proper. closure height is measured from the closure top to the open end of the closure. closure height can be considered in terms of “inside height” or “outside height.”
|
|
|
|
|
|
|
